acrer extensa 5220
witam, pobrałem i zainstalowałem najnowszą dystrybucje mint
zrobiłem wszystkie update, po lanie śmiga, ale jak chcę podłączyć wifi
to nie pokazuje mi, ściągnąłem jakieś stery pod linuxa ale nie działają
mint@mint-laptop ~ $ sudo cat /etc/network/interfaces
auto lo
iface lo inet loopback
mint@mint-laptop ~ $ sudo lshw -C network
*-network
description: Ethernet interface
product: NetLink BCM5787M Gigabit Ethernet PCI Express
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:02:00.0
logical name: eth0
version: 02
serial: 00:1d:72:0a:42:6f
capacity: 1GB/s
width: 64 bits
clock: 33MHz
capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=3.94 firmware=5787m-v3.23 latency=0 link=no module=tg3 multicast=yes port=twisted pair
*-network
description: Network controller
product: BCM4311 802.11b/g WLAN
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:04:00.0
version: 01
width: 32 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list
configuration: driver=b43-pci-bridge latency=0 module=ssb
*-network:0 DISABLED
description: Wireless interface
physical id: 1
logical name: wlan0
serial: 00:1e:4c:2c:36:2a
capabilities: ethernet physical wireless
configuration: broadcast=yes multicast=yes wireless=IEEE 802.11bg
*-network:1 DISABLED
description: Ethernet interface
physical id: 2
logical name: pan0
serial: 7e:7a:ab:75:18:fd
capabilities: ethernet physical
configuration: broadcast=yes driver=bridge driverversion=2.3 firmware=N/A link=yes multicast=yes
mint@mint-laptop ~ $ sudo cat /etc/resolv.conf
# Generated by NetworkManager
mint@mint-laptop ~ $ sudo route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
mint@mint-laptop ~ $ sudo ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:1d:72:0a:42:6f
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:16
irda0 Link encap:IrLAP HWaddr 00:00:00:00
NOARP MTU:2048 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:8
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:40 errors:0 dropped:0 overruns:0 frame:0
TX packets:40 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2784 (2.7 KB) TX bytes:2784 (2.7 KB)
pan0 Link encap:Ethernet HWaddr 7e:7a:ab:75:18:fd
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wlan0 Link encap:Ethernet HWaddr 00:1e:4c:2c:36:2a
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wmaster0 Link encap:UNSPEC HWaddr 00-1E-4C-2C-36-2A-00-00-00-00-00-00-00-00-00-00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
nie wiem co mam zrobić aby te wifi działało pod windowsem 7 śmiga a tutaj jakoś lamie ;|
