wifi działa, a internet po kablu nie działa

[jaro55107]

0

Uciąłeś komendę, spojrzyj jeszcze raz.
Te najważniejsze elementy są.
To jeszcze na 10Mbps próba.
sudo ethtool -s ens5f5 speed 10 duplex half && sleep 2 && ethtool ens5f5 && ip address
Pamiętaj, pełny wynik wklej, razem z komendą wywołującą.

Kod:

~$ sudo ethtool -s ens5f5 speed 10 duplex half && sleep 2 && ethtool ens5f5 && ip address
Settings for ens5f5:
    Supported ports: [ TP MII ]
    Supported link modes:   10baseT/Half 10baseT/Full
                            100baseT/Half 100baseT/Full
                            1000baseT/Half 1000baseT/Full
    Supported pause frame use: No
    Supports auto-negotiation: Yes
    Supported FEC modes: Not reported
    Advertised link modes:  Not reported
    Advertised pause frame use: No
    Advertised auto-negotiation: No
    Advertised FEC modes: Not reported
    Speed: 10Mb/s
    Duplex: Half
    Port: MII
    PHYAD: 1
    Transceiver: internal
    Auto-negotiation: off
Cannot get wake-on-lan settings: Operation not permitted
    Current message level: 0x000020c6 (8390)
                   probe link rx_err tx_err hw
    Link detected: no
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host
       valid_lft forever preferred_lft forever
2: ens5f5: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
    link/ether 20:cf:30:65:7e:ae brd ff:ff:ff:ff:ff:ff
3: wls1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
    link/ether 48:5d:60:3b:68:94 brd ff:ff:ff:ff:ff:ff
    inet 192.168.0.13/27 brd 192.168.0.31 scope global dynamic noprefixroute wls1
       valid_lft 79849sec preferred_lft 79849sec
    inet6 ::7069:9793:6c88:a/64 scope global temporary dynamic
       valid_lft 3598sec preferred_lft 3598sec
    inet6 ::9df2:9a72:60a2:95c1/64 scope global dynamic mngtmpaddr noprefixroute
       valid_lft 3598sec preferred_lft 3598sec
    inet6 fe80::ee3b:9bf8:226c:3224/64 scope link noprefixroute
       valid_lft forever preferred_lft forever

wszystko co mogłem to skopiowałem
a czy przyczyna tego moze być ze mam wersjie 32 bity a windowsa miałem 64 bity ?