Niemontowanie USB

[KappV]

0

po wpisaniu "dmesg -w" cały czas przewija się ten sam napis:

Kod:

[ 1322.752887] intel ips 0000:00:1f.6: ME failed to update for more than 1s, likely hung

do tego raz na jakiś czas:

Kod:

[ 1033.606494] [UFW BLOCK] IN=wlp3s0 OUT= MAC=01:00:5e:00:00:01:90:72:82:e2:a0:b9:08:00 SRC=192.168.1.1 DST=224.0.0.1 LEN=32 TOS=0x00 PREC=0x80 TTL=1 ID=0 DF PROTO=2

kiedy podczas tego przewijania wsadzę pendrive'a wyskakuje:

Kod:

[ 1246.601650] usb 2-1.3: new high-speed USB device number 3 using ehci-pci
[ 1246.621661] intel ips 0000:00:1f.6: ME failed to update for more than 1s, likely hung
[ 1246.715283] usb 2-1.3: New USB device found, idVendor=090c, idProduct=1000
[ 1246.715289] usb 2-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 1246.715291] usb 2-1.3: Product: Flash Drive
[ 1246.715294] usb 2-1.3: Manufacturer: Samsung
[ 1246.715297] usb 2-1.3: SerialNumber: 0352916010019198
[ 1246.718507] usb-storage 2-1.3:1.0: USB Mass Storage device detected
[ 1246.718699] scsi host4: usb-storage 2-1.3:1.0

potem znowu kilka razy

Kod:

[ 1322.752887] intel ips 0000:00:1f.6: ME failed to update for more than 1s, likely hung

i wtedy:

Kod:

[ 1248.027962] scsi 4:0:0:0: Direct-Access    Samsung  Flash Drive      1100 PQ: 0 ANSI: 6
[ 1248.028464] sd 4:0:0:0: Attached scsi generic sg2 type 0
[ 1248.029561] sd 4:0:0:0: [sdb] 31326208 512-byte logical blocks: (16.0 GB/14.9 GiB)
[ 1248.030552] sd 4:0:0:0: [sdb] Write Protect is off
[ 1248.030557] sd 4:0:0:0: [sdb] Mode Sense: 43 00 00 00
[ 1248.031568] sd 4:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 1248.037596]  sdb: sdb1
[ 1248.041571] sd 4:0:0:0: [sdb] Attached SCSI removable disk

dalej znów to co zwykle

przez cały czas pisania posta pendrive nie zamontował się

Używaj CODE!