0
Kod:
a@a:~$ dmesg | tail -n 20
[ 7509.348708] hub 4-1:1.0: USB hub found
[ 7509.350721] hub 4-1:1.0: 4 ports detected
[ 8425.530657] usb 4-1: USB disconnect, device number 7
[ 8553.604864] perf: interrupt took too long (6304 > 6292), lowering kernel.perf_event_max_sample_rate to 31500
[11522.070649] usb 3-1: new full-speed USB device number 2 using uhci_hcd
[11522.260682] usb 3-1: New USB device found, idVendor=0a05, idProduct=7211
[11522.260685] usb 3-1: New USB device strings: Mfr=0, Product=1, SerialNumber=0
[11522.260687] usb 3-1: Product: USB2.0 HUB
[11522.263745] hub 3-1:1.0: USB hub found
[11522.265679] hub 3-1:1.0: 4 ports detected
[11827.624800] usb 3-1: USB disconnect, device number 2
[14355.305038] e1000e: enp0s25 NIC Link is Down
[14357.321873] e1000e: enp0s25 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[14357.321980] e1000e 0000:00:19.0 enp0s25: 10/100 speed: disabling TSO
[14369.416561] e1000e: enp0s25 NIC Link is Down
[14371.433239] e1000e: enp0s25 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[14371.433347] e1000e 0000:00:19.0 enp0s25: 10/100 speed: disabling TSO
[14383.528121] e1000e: enp0s25 NIC Link is Down
[14385.544781] e1000e: enp0s25 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[14385.544888] e1000e 0000:00:19.0 enp0s25: 10/100 speed: disabling TSO
a@a:~$Podając wyniki komend bądź logi proszę używać znaczników - CODE. Wynik podajemy razem z poleceniem, które je wywołuje
