15-11-2020, 18:33
0
Kod:
a@a:~$ dmesg | tail -n 20
[11522.260685] usb 3-1: New USB device strings: Mfr=0, Product=1, SerialNumber=0
[11522.260687] usb 3-1: Product: USB2.0 HUB
[11522.263745] hub 3-1:1.0: USB hub found
[11522.265679] hub 3-1:1.0: 4 ports detected
[11827.624800] usb 3-1: USB disconnect, device number 2
[14355.305038] e1000e: enp0s25 NIC Link is Down
[14357.321873] e1000e: enp0s25 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[14357.321980] e1000e 0000:00:19.0 enp0s25: 10/100 speed: disabling TSO
[14369.416561] e1000e: enp0s25 NIC Link is Down
[14371.433239] e1000e: enp0s25 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[14371.433347] e1000e 0000:00:19.0 enp0s25: 10/100 speed: disabling TSO
[14383.528121] e1000e: enp0s25 NIC Link is Down
[14385.544781] e1000e: enp0s25 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[14385.544888] e1000e 0000:00:19.0 enp0s25: 10/100 speed: disabling TSO
[65947.926722] usb 4-2: new full-speed USB device number 8 using uhci_hcd
[65948.128761] usb 4-2: New USB device found, idVendor=0a05, idProduct=7211
[65948.128764] usb 4-2: New USB device strings: Mfr=0, Product=1, SerialNumber=0
[65948.128766] usb 4-2: Product: USB2.0 HUB
[65948.132358] hub 4-2:1.0: USB hub found
[65948.133756] hub 4-2:1.0: 4 ports detected
a@a:~$Tutaj podłączony przez czteroportowy hub.
Też go nie wykrywa. Z tym, że jest to jakiś tani hub 2.0, ale wszystkie inne dyski na nim działają.
Czy gdyby był to hub 3.0 coś by to zmieniło?